The washing machine fills with water while switched off

Water appearing while the washing machine is switched off may be coming from the water supply or flowing back through the drain. Restarting the machine will not stop either of these physical causes.

Relate when the water appears to the water supply and drain

Turn off the washing machine’s water taps if you can do so safely, and prevent water from building up again. Note whether the problem started after using a sink, dishwasher or another appliance connected to the same waste pipe. This may point to water flowing back from the drain.

A slow inflow while the water supply is turned on may indicate a valve that is not sealing properly. If the water stops reappearing when you turn off the supply, this observation can help with diagnosis, but it does not mean you should dismantle the valve or that an inspection of the pipework is unnecessary.

Do not rely on appearance alone

Clear water does not necessarily mean it is fresh: water flowing back from the drain may be diluted. Cloudy water does not always identify the pipe either, as residue in the drum can dirty incoming water. The timing, recurrence and connection with each water supply are more useful clues.

If a mechanical fault is suspected, the solenoid valve needs to be diagnosed. Disconnecting the electricity prevents the appliance from being activated, but it will not stop a valve that is mechanically letting water through.

If there is water near electrical sockets, do not go near them to unplug the appliance. Isolate the electricity from a dry location and seek help if you cannot control the water flow.

Keep the water supply turned off until you find the cause; leaving the machine switched off does not guarantee that it will stay empty.

View all articles in Filling, water-level and drainage problems