If the water level rises abnormally or looks as though it may overflow, stop using the machine and shut off the water supply from a safe place. The first priority is to stop the water coming in, not to restart the programme.
Contain the water without exposing yourself to wet connections
If you can reach them safely, turn off the water supply taps. Isolate the electricity from a dry place; do not reach for a plug surrounded by water. Do not force the door open or remove the filter cap while the drum is full.
Describe what you have already observed: whether the water level continued to rise after you switched the machine off, whether foam appeared and at what stage it started. Do not leave the water running to recreate a flood.
What each observation means
- Water entering while the machine is idle: distinguish a valve that is not closing from an external backflow. See water filling when the machine is off.
- Water building up while the controls are calling for water: the level-detection circuit may be involved, as well as the water inlet control.
- Foam filling the glass: this does not necessarily mean there is an equal volume of water. The detergent and programme should be included in the record.
The normal water level depends on the machine’s design, programme and load. An additional fill that is part of the programme does not in itself indicate overfilling; the concern is a rise that cannot be controlled or exceeds the documented limits.
The technician should check both that the solenoid valve closes properly and the system signals. Adjusting the pressure-switch screws or blowing into electronic sensors can alter or damage components.
If you cannot stop the water supply or water reaches electrical installations, move away from the area and seek emergency assistance appropriate to the situation.
View all articles in Filling, water-level and drainage problems
