The washing machine won’t start, stops or won’t finish the programme

The washing machine won’t start, stops or won’t finish the programme

The control panel status helps distinguish a programme pause from an interruption or a loss of power. Note any messages and the programme stage before cancelling or resetting.

Start with what the controls are doing

Observed statusTroubleshooting
It switches on and lets you select a programme, but won’t startStart conditions
It was washing, then stoppedStops part-way through the programme
Keeps running or repeats without finishingRepeated stages and time remaining
Ignores buttons or programme selector positionsPanel and controls
The lights go out and it returns to the startPower-offs and restarts

Statuses that may be normal

Delay start, soaking, cooling, control lock and load balancing can change how the machine responds. A timer that does not advance for a while does not necessarily mean it is faulty.

The manual explains which indicators correspond to these statuses. If this behaviour is new, prevents a programme from finishing or coincides with retained water, noise or heating, note that context for diagnosis.

Before clearing the status

Photograph the exact message and note the water, load and programme stage. The cancellation or reset can restore a control status, but it will not repair a leak or a damaged part. If there are signs of an electrical fault, do not use resetting as a repeated test.

Frequently Asked Questions

Does a countdown that has stopped prove the washing machine is faulty?

No. The estimated time may stay the same while the machine completes an operation or redistributes the load. Repeated occurrences and a failure to complete the programme can help identify a problem.

Should I note the code before resetting?

Yes. Note the exact code and any pattern of lights, as well as the programme stage. Resetting may erase information that explains why the controls stopped.

Are locked controls and a faulty control panel the same thing?

No. A control lock setting can normally disable certain commands. A faulty button, selector or interface should be investigated after checking whether that setting is active.

First look for the condition that the programme cannot complete; the electronics may be responding to a problem with water, the door lock or movement.