Turning, agitation and spinning faults

Turning, agitation and spinning faults

Washing by movement and spinning are different operations. To locate the fault, check which movement the design is intended to make and whether the washing machine manages to drain the water.

Movement depends on the design

A horizontal drum tumbles the laundry; a vertical-axis machine may use an agitator or impeller. Spinning speeds up the relevant assembly to extract water. Not all parts rotate in the same way during both phases.

Pauses, changes of direction and movements to redistribute the load may be programmed. Compare what happens with normal operation and the manual before treating a stoppage as a fault.

Choose the symptom you actually observe

  • If it moves during washing but does not extract water from the laundry, see no or insufficient spinning.
  • If an automatic vertical-axis machine fills but does not move the laundry, check no agitation.
  • If it should tumble but remains still, use the diagnosis for a stationary horizontal drum.
  • If you notice unusual resistance with the machine isolated from the power supply, distinguish between a mechanical jam and resistance that is part of the design.
  • If the drum is off-centre, rubs against something or moves independently of the tub, see excessive play and a dropped drum.

The motor may be waiting for another condition

An unrecognised door lock, retained water or a protective state may prevent movement even when the motor is not the cause. A cycle that works with no load does not identify a particular part either: the load affects effort, balance and control.

Do not repeat spin cycles if there is violent banging, rubbing or a dropped drum. Never fool a sensor to observe the drum spinning with the lid open.

Frequently Asked Questions

Can it turn during washing but fail to spin?

Yes. High-speed spinning requires the machine to be drained, balanced and locked—conditions that may not prevent movement during washing. Part of the drive system may also fail under certain conditions.

Do pauses in the drum always indicate a fault?

No. The programme may include soaking, sensing, changes of direction and redistribution of the laundry. Check whether it resumes and completes the intended cycle.

Why should you not test the spin with the lid open?

The lid and its interlock protect you from moving parts. Do not hold down sensors or bypass contacts to watch the mechanism running.

Explain which movements the machine still performs; knowing that it washes but does not spin narrows down the checks more than saying that it “does not turn”.