
To locate a leak, note where the water first appears and at what stage. The resulting puddle may be some distance from the source because water can run along the casing or floor.
Stop the leak before investigating
Stop using the machine and turn off the water supply if you can do so safely. If water reaches electrical connections, do not touch plugs or the casing to check: isolate the power from a dry, safe place. Do not run the washing machine with the casing open to inspect the inside.
Where the water first appears can guide your checks
- Water underneath the machine: note whether it appears during filling, washing or draining, and whether the machine has been serviced recently.
- Leak around the door: check the contact surface, the seal and the alignment.
- Overflow from the detergent drawer: distinguish water from foam, and note when the detergent is dispensed.
- Dripping from the filter or cap: check whether it started after you opened the drain access panel.
An external inlet connection can leak even when the machine is idle if it remains under pressure. A household drain that overflows during pumping calls for a plumbing repair, even if the puddle is around the washing machine.
Details worth keeping
Make a note of the programme, the load and whether you had just cleaned a filter, repositioned the detergent drawer or moved the machine. These changes can help you decide what to check first. Do not use glue or sealant on a connection if you have not identified its sealing mechanism.
Frequently Asked Questions
Does the location of the puddle always identify the part that is leaking?
No. Water can run down the front or along a hose before dripping. Where it first gets wet provides more information than the centre of the puddle.
Can a leak occur only on certain programmes?
Yes. The water level, dispensing stages, movement and draining operations vary. This relationship can help locate the leak without confirming a specific part.
Is it safe to keep using the washing machine if the leak is small?
You should not assume it is safe just because the leak is small. Water could reach electrical connections or the leak could get worse. Stop using the machine until you have identified and fixed the source.
A follow-up test is only appropriate once the cause has been fixed and all connections and protective devices have been restored.




