How to reset a washing machine and when it may help

A reset can restore a control state, but it will not fix a leak, blockage or damaged part. Before doing so, note the message and check for any signs of danger.

Four different actions

ActionWhat changes
Cancel the cycleStops the operation using the controls and may start draining or a waiting period
Reset the powerSwitches the appliance off and back on using the permitted procedure
Reset settingsMay erase preferences or connections, depending on the model
Enter diagnostic modeOpens testing functions; this is not the same as a routine reset

Before following a sequence

Keep a record of the exact code, programme, stage and any visible water. Check for leaks, electric shocks, smoke, odours or unusual heating. If any of these occur, stop using the appliance rather than trying to clear the warning.

Check the manual for your model and market for the button presses and waiting times. There is no universal combination, and unplugging the appliance should not be assumed to unlock the door immediately.

How to interpret the result

If the controls become responsive again, check what the original condition was: failure to start, cycle stopping or unresponsive panel. If the fault reappears, the reset has restored a state without removing its cause.

Do not repeat the operation in a loop or try technical modes from an unknown source. Some functions change settings that users do not need to alter.

Use the permitted recovery procedure as a specific diagnostic step, not as proof that the washing machine has been repaired.

View all articles in The washing machine won’t start, stops or won’t finish the programme