If the control panel switches off and returns to the start during a wash, distinguish a power interruption from a control reset. A pause with the indicators still lit requires a different diagnosis.
Observations you can note
Note what stage of the cycle it was at when it switched off, whether any other lights in the home changed, and whether the display returns to the programme or the initial selection screen. Also record any recent changes to the connections or the appliance’s location.
There is no need to repeat the episode with a heavier load or a higher temperature to identify a pattern. If there is a smell or signs of heat damage, follow the advice for burning or smoke.
External power supply and internal electronics
A poor connection, an interruption to the supply, or a problem with the power supply or controls can produce similar symptoms. If a protective device trips, use the guidance for electrical trips and do not keep resetting it.
Electrolux refers supply problems to an electrician and advises against using extension leads in its guidance on circuit loading and connections. The specific circuit capacity requirements depend on the local installation.
If the supply has been checked
An inspection of the control board, power supply and connections should take into account external loads that could cause the fault. Do not install a generic voltage stabiliser to compensate for an unidentified fault.
How to resume a programme after a power cut varies by model. Follow the manual and check which operations were actually completed before treating the load as washed.
Note whether switching off clears the selection or resumes the cycle; this difference helps assess the power supply and controls.
View all articles in The washing machine won’t start, stops or won’t finish the programme
