The washer won’t start, stops or won’t finish the cycle

The washer won’t start, stops or won’t finish the cycle

The control panel status can help distinguish a programme pause from an interruption or loss of power. Note any messages and the cycle stage before cancelling or restarting.

Start with what the controls are doing

Observed statusPath
Powers on, lets you choose a cycle and doesn’t startStart conditions
Was washing, then stoppedStopped partway through the cycle
Keeps running or repeats without finishingRepeated stages and time remaining
Ignores buttons or selector positionsPanel and controls
Lights go out and it returns to the beginningPower-offs and restarts

Statuses that may be expected

Delay start, soak, cool-down, control lock and load redistribution can affect the machine’s response. A timer that does not advance for a while does not necessarily mean it is faulty.

The manual explains which indicators correspond to these statuses. If the behaviour is new, prevents a cycle from finishing or occurs along with retained water, noise or heating, note that context for diagnosis.

Before clearing the status

Take a photo of the exact message and note the water, load and cycle stage. Cancelling or restarting may restore the controls, but it won’t fix a leak or a damaged part. If there are signs of an electrical issue, don’t use repeated resets as a test.

Frequently Asked Questions

Does a countdown that stops mean the washer is faulty?

No. The estimated time may stay the same while the machine completes an operation or redistributes the load. Recurring pauses and an unfinished cycle can help identify a problem.

Should I record the code before restarting?

Yes. Note the exact code and any light pattern, as well as the cycle stage. Restarting may erase information that explains why the controls stopped.

Are locked controls and a faulty panel the same thing?

No. A control lock setting can normally disable certain commands. Investigate a faulty button, selector or interface only after checking whether that setting is on.

First, look for the condition the cycle can’t complete; the electronics may be responding to a problem with water, the door lock or movement.