ASKO error E3: filling problems

E3 on the ASKO WM76S indicates a filling problem. Check the water supply, inlet and drain positioning as described in the W3096RW manual before trying again.

From the tap to the water level

The manufacturer’s documentation covers the tap, inlet mesh filter, hose and drain height. First check whether there is a water supply and whether a tap has been turned off. Check the hose for any kinks or deformation.

If water enters but does not stay in the machine, note whether it drains away at the same time. Compare the height and connection with the installation section: a set-up that encourages siphoning cannot be fixed by restarting the control panel.

Accessible mesh filter and recovery

If the manual allows you to clean the inlet, turn off the water, prepare the appliance and disconnect only the specified connection. Refit the mesh filter and seal, then check for leaks. The inlet filter guide provides further preparation advice.

The WM76S manual says to continue by confirming on the control panel after checking the conditions. If E3 appears again, contact service and provide the model and your observations about the filling process. Permitted pressures are specified in the manual; do not apply its limits to other ASKO generations.

Distinguish restoring the water supply from clearing the message: only the former fixes a water supply interruption.

View all articles in ASKO washing machine error codes and warnings