The washing machine fills with water while turned off

Water appearing when the washing machine is off may be coming from the water supply or backing up through the drain. A reset won’t stop either of these physical sources of water.

Relate when the water appears to the water supply and drain

Close the washing machine’s water supply taps if you can do so safely, and prevent water from building up again. Note whether the problem started after using a sink, dishwasher, or another appliance connected to the same drain. That connection points towards backflow from the drain.

A slow flow of water while the supply is on may point to a valve that isn’t sealing. If the water stops reappearing when you shut off the supply, that observation can help with diagnosis, but it doesn’t mean you should dismantle the valve or skip having the drain path inspected.

Don’t rely on appearance alone

Clear water doesn’t necessarily mean it’s fresh water: backflow can be diluted. Cloudy water doesn’t always identify the pipe either, since residue in the tub can make incoming water look dirty. The timing, recurrence, and connection to each water supply are more useful clues.

If a mechanical seal failure is suspected, the solenoid valve needs to be diagnosed. Disconnecting the power prevents the machine from being activated, but it won’t stop a valve that is mechanically allowing water through.

If there’s water near electrical outlets, don’t approach them to unplug the machine. Shut off the power from a dry location, and get help if you can’t control the water supply.

Keep the water supply shut off until you find the cause; leaving the machine turned off doesn’t guarantee it will stay empty.

View all articles in Problems with filling, water level and draining