The washing machine fills and drains at the same time

If water drains while the washing machine is trying to fill, check how the model drains and how the hose is installed. Siphoning can occur without the pump driving the water.

Does the water drain on its own, or is the pump running?

Note whether you hear the pump running and whether the control panel shows a warning. The sound helps describe what happened, but on its own it doesn’t confirm which component is operating. If continuous pumping is confirmed, follow the diagnostic steps for the pump that won’t stop.

On a gravity-drain machine, check that the drain selector hasn’t been left open. Its installation differs from that of an automatic washer designed to lift water with a pump.

Check the drain setup against the manual

The height of the drain outlet, how far the hose is inserted, and air intake at connections where required can affect unintended draining. Whirlpool documents this issue in its explanation of siphoning during the fill cycle; its recommendations apply to the machines described, not all washing machines.

Don’t seal a connection that requires air intake with tape or improvise a raised hose position. Compare the setup with the guide to drain hose height, securing and siphoning and the documentation for your model.

If the installation matches the instructions and the controls continue alternating between filling and draining, the water-level system and any activated safety feature should be checked. Don’t repeat fill cycles indefinitely.

Distinguish this from water returning after the cycle ends: when filling and draining happen at the same time, the diagnostic process changes.

View all articles in Problems with filling, water level and draining