Sud or Sd indicates excessive suds in compatible Whirlpool washers. The washer may add rinse cycles and limit spinning while it tries to remove them.
Give the washer time to clear the suds
For front-load washers, the manufacturer's documentation describes pauses and additional rinses. If the washer continues this routine without leaking, don't add detergent or repeatedly cancel the cycle to speed things up. The duration depends on how much needs to be rinsed away and on the programme.
Review the total amount used
Check that the detergent is HE if the manual requires it. Also count any additives and products used to pretreat laundry: the amount in the dispenser isn't always all that goes into the drum. More concentrated products, softer water or a smaller load may require a lower dose.
If you changed detergents, compare the directions on both containers; using the old measure again may result in too much of the new detergent. The detergent amount guide can help you adjust the dose for the load size and soil level.
Suds and restricted draining
Check the drain hose: a kink or restriction may also trigger the warning. If the washer stops again or retains water after you correct the product and dose, contact support. Don't pour in oil, extra fabric softener or homemade mixtures to make the bubbles disappear.
Assess the next wash using the corrected dose; clearing Sud doesn't indicate how much detergent remains in the laundry.
View all articles in Whirlpool washer error codes and alerts
