F7 E1 indicates a speed-sensing issue on the documented Whirlpool front-load washer: the motor does not reach the speed required by the cycle.
If the washer was just installed or the load changes
The manufacturer's documentation recommends checking the shipping materials and for an overloaded washer. If the first wash fails, check the unpacking section of the manual and confirm that the installer removed the required shipping restraints. Do not run the washer to see what happens with them in place.
If the error started with an especially large load, stop the cycle, wait for the door to unlock, and reduce the amount of laundry to suit the cycle. Selecting a higher spin speed does not make an oversized item suitable for the load.
What the code indicates and what still needs diagnosing
F7 E1 describes a speed that the control cannot confirm. On its own, it does not prove that the motor, a sensor, or the electronics are faulty. Note whether the drum tries to turn, whether the error appears when the washer starts or during the spin cycle, and whether it began after the washer was moved.
Only retry the procedure provided for the control panel after correcting the accessible condition. If the error returns, request service. The explanation of the speed sensor helps explain what a technician needs to check; there is no need to test circuits or take the motor apart.
Stop using the washer if it makes unusual banging noises when trying to turn or moves out of place.
View all articles in Whirlpool washer error codes and alerts
