HC alert on a Whirlpool washer: hot and cold water connections reversed

HC indicates that the hot and cold water connections are reversed on the documented Whirlpool HE top-load washers. It applies only to machines that use both inlets.

Check the routing of each hose

The manufacturer’s documentation identifies HC at the end of the cycle. Before changing anything, identify the household hot-water outlet, the cold-water outlet, and the markings on the washer inlets. Trace each hose from one end to the other; its colour alone does not confirm the connection.

  1. Stop the appliance and turn off both taps.
  2. If the manual authorizes correcting these connections and you can access them without pulling the machine out, have a container ready to catch any residual water.
  3. Connect each water supply to its inlet according to the model diagram, keeping the approved hoses and washers in place.
  4. Turn the water supply back on and check the connections for leaks before running an authorized test cycle.

If you can’t identify an outlet or access requires moving a heavy or stacked appliance, ask the installer for help. The guide to a hot or cold water supply that isn’t working distinguishes a reversed connection from a lack of water supply.

HC after correcting the installation

Record when it reappears and which connections were checked. A persistent message requires diagnosis; don’t repeatedly switch the hoses or apply this meaning to a single-inlet Whirlpool washer.

The check is complete when the connections are correct and leak-free, not just when HC disappears.

View all articles in Whirlpool washer error codes and alerts