The inlet needs a compatible hose, the correct seals and an accessible tap. The connection must be watertight and free from strain; a similar appearance or approximate diameter does not prove compatibility.
What to identify before connecting
Check the inlet type, tap connection, fittings and approved hose. A conventional hose and a set with leak protection may have different requirements for orientation, extension and replacement.
If the threads or available space do not match, an installer should assess the required adaptation. Do not force a fitting or improvise with reducers just because it starts to screw on: a poorly seated connection may leak under pressure.
Sequence subject to the manual
- With the appliance isolated and the tap turned off, inspect the mating surfaces, seals and condition of the hose.
- Fit the seals and connections in the order and orientation specified.
- Screw the connection on without cross-threading it, and use only the approved tightening method.
- Route the hose without kinks, rubbing or tension on the fitting.
- Turn the water back on as instructed, then check externally for leaks.
A flat seal and a thread from a different system may seal differently. Do not add tape or sealant, or use a tightening torque taken from another installation.
Before positioning the appliance permanently
Keep the shut-off accessible and check the required pressure and flow rate . For a dual inlet, check each water supply separately. After moving the appliance into position, check the hose routing again and carry out the installation test.
If there is a leak, turn off the water supply and check the cause of the connection issue; tightening it more and more is no substitute for identifying an incorrect seal or connection.
View all articles in Installing a washing machine: requirements and checks
