Connecting the water inlet: compatible taps, hoses and seals

The inlet requires a compatible hose, the correct seals and an accessible tap. The connection must be watertight and free from strain; a similar appearance or approximate diameter does not prove compatibility.

What to identify before connecting

Check the inlet type, tap connection, fittings and approved hose. A standard hose and an assembly with leak protection may have different requirements for orientation, extension and replacement.

If the threads or available space do not match, ask an installer to assess the adaptation. Do not force a fitting or improvise with reducers just because it starts to screw in: a poorly seated connection may leak under pressure.

Procedure subject to the manual

  1. With the appliance isolated and the tap closed, inspect the joining surfaces, seals and condition of the hose.
  2. Position the seals and connections in the order and orientation specified.
  3. Screw the connection together without cross-threading and use only the approved tightening method.
  4. Route the hose without kinks, rubbing or strain on the fitting.
  5. Turn the water back on as instructed and check externally for leaks.

A flat seal and a thread from a different system may seal differently. Do not add tape or sealant, or use a tightening torque from another installation.

Before positioning the appliance permanently

Keep the shut-off valve accessible and check the required pressure and flow rate . For a dual water supply, check each supply separately. After moving the appliance into position, check the hose routing again and carry out the installation test.

If there is a leak, shut off the water supply and check the cause at the connection; tightening it further and further is no substitute for identifying an incorrect seal or connection.

View all articles in Washing machine installation: requirements and checks