Connecting the water inlet: compatible taps, hoses and seals

The inlet requires a compatible hose, the correct seals and an accessible tap. The connection must be watertight and free from strain; a similar appearance or approximate diameter does not prove compatibility.

What to identify before connecting

Check the inlet type, tap connection, fittings and approved hose. A standard hose and an assembly with leak protection may have different requirements for orientation, extension and replacement.

If the threads or available space do not match, an installer should assess whether an adapter is suitable. Do not force a fitting or improvise with reducers just because it starts to screw in: a poorly seated connection can leak under pressure.

Procedure subject to the manual

  1. With the appliance isolated and the tap turned off, inspect the connection surfaces, seals and condition of the hose.
  2. Fit the seals and connections in the order and orientation specified.
  3. Screw the connection on without cross-threading it, and use only the approved tightening method.
  4. Route the hose without kinks or rubbing, and without putting strain on the fitting.
  5. Turn the water back on as instructed and check externally for leaks.

A flat seal and a thread from a different system may seal in different ways. Do not add tape or paste, or use a tightening torque taken from another installation.

Before positioning the appliance permanently

Keep the shut-off valve accessible and check that the pressure and flow rate meet the requirements. For a dual inlet, check each water supply separately. After moving the appliance into position, check the hose routing again and carry out the installation test.

If there is a leak, turn off the water supply and check the cause at the connection; tightening it further each time is no substitute for identifying an incorrect seal or connection.

View all articles in Washing machine installation: requirements and checks