The inlet requires a compatible hose, the correct seals and an accessible faucet. The connection must be watertight and free of strain; a similar appearance or approximate diameter does not prove compatibility.
What to identify before connecting
Check the inlet type, faucet connection, fittings and approved hose. A standard hose and an assembly with leak protection may have different requirements for orientation, extension and replacement.
If the threads or available space do not match, an installer should assess the adaptation. Do not force a fitting or improvise with reducers just because it starts to thread on: a poorly seated connection can leak under pressure.
Sequence subject to the manual
- With the appliance isolated and the faucet closed, inspect the connection surfaces, seals and condition of the hose.
- Position the seals and connections in the order and orientation specified.
- Thread the connection on without cross-threading, and use only the approved tightening method.
- Route the hose without kinks, rubbing or strain on the fitting.
- Restore the water supply as directed by the procedure and check externally for leaks.
A flat seal and a thread from a different system may seal differently. Do not add tape or paste, or use a tightening torque from another installation.
Before positioning the appliance permanently
Keep the shut-off accessible and verify the required pressure and flow rate. For a dual inlet, check each supply separately. After moving the appliance into position, check the hose routing again and perform the installation test.
If there is a leak, shut off the water supply and check the cause at the connection; tightening it more and more is no substitute for identifying an incorrect seal or connection.
View all articles in Washing machine installation: requirements and checks
