Water passes from the wash tub to the spin tub

Water reaching the spin tub may enter through an intended function, a mispositioned selector or a drain that is not flowing freely. This alone does not prove there is a hole between the tubs.

Observe where the water enters

Stop the water supply if the level rises uncontrollably. From outside the machine and without removing any guards, note whether the water falls from above or reappears from below while the wash tub drains.

Some machines allow rinsing directly into the basket. Before calling it a leak, check the selector, the position of the fill hose and the selected operation in the manual.

Consider the inlet and drain together

Haier distinguishes between water entering from above and drainage problems in its guide to water passing between tubs. That example does not provide universal heights or flow rates.

If the issue coincides with slow draining, check the drainage path of the semi-automatic washer. A shared outlet that is not draining properly should be checked before suspecting that a crack is connecting the two tubs.

When the machine needs to be opened

If the controls and visible connections are set up according to the manual and water still enters when it should not, arrange an inspection of the ducts and joints. Do not seal internal passages or cut hoses to change the flow path.

Record whether it happens only at a high flow rate or also while the machine is idle. This information helps the technician reproduce the problem under controlled conditions.

Do not use this explanation for a single-tub automatic washer: the separation of the tubs and the selectors change the circuit.

View all articles in Faults with semi-automatic and twin-tub washing machines