Water reaching the spin tub may enter through a designed function, a mispositioned selector or a drain that is not flowing freely. This does not, by itself, prove there is a hole between the tubs.
Check where the water is coming in
Stop the water supply if the level rises uncontrollably. From the outside, without removing any guards, note whether the water falls from above or reappears from below while the wash tub is draining.
Some machines allow rinsing directly into the basket. Before calling it a leak, check the selector, the position of the fill hose and the selected operation in the manual.
Consider the inlet and drain together
Haier distinguishes between water entering from above and drainage problems in its guide to water passing between tubs. This example does not provide universal heights or flow rates.
If this happens while the tub is draining slowly, check the drainage route on the semi-automatic machine. If a shared outlet is not draining, it should be checked before suspecting that a crack is connecting the two tubs.
When the machine needs to be opened
If the controls and visible connections match the manual but water still enters when it should not, arrange an inspection of the ducts and joints. Do not seal internal passages or cut hoses to change the route.
Note whether it happens only at a high flow rate or also when the machine is idle. This information will help the technician reproduce the problem under controlled conditions.
Do not use this explanation for a fully automatic machine with a single tub: the tub separation and selectors change the circuit.
View all articles in Faults with semi-automatic and twin-tub washing machines
