Water passes from the wash tub to the spin tub

Water reaching the spin tub may enter through an intended function, a wrongly positioned selector or a drain that is not flowing. This alone does not prove there is a hole between the tubs.

Observe where it enters

Stop the water supply if the level rises uncontrollably. From outside and without removing any protective covers, note whether water falls from above or reappears from below while the wash tub drains.

Some appliances allow rinsing directly into the basket. Check the selector, fill hose position and selected operation in the manual before calling it a leak.

Relate the inlet to the drain

Haier distinguishes water flowing in from above from drainage problems in its guide to water passing between tubs. That example does not provide universal heights or flow rates.

If this happens along with slow draining, check the drainage route of the semi-automatic machine. A shared outlet that does not drain properly should be checked before suspecting a crack connecting the two tubs.

When the appliance needs to be opened

If the controls and visible connections are as described in the manual but water continues to enter where it should not, request an inspection of the ducts and joints. Do not seal internal passages or cut hoses to change the water route.

Note whether this happens only at a high flow rate or also when the appliance is idle. This helps the technician reproduce the problem in a controlled way during the inspection.

Do not use this explanation for a single-tub automatic washing machine: the separation between tubs and its selectors change the circuit.

View all articles in Faults in semi-automatic and twin-tub washing machines