Pressure switch and level sensor: fault diagnosis

Level diagnosis should include the pressure chamber, tube and sensor. Replacing only the pressure switch may leave a blockage or leak that continues to affect the reading.

Identify the type of detection

A mechanical pressure switch can switch contacts; an electronic sensor provides a signal that needs to be interpreted differently. Configurations without the same tube and chamber assembly may also exist.

See how a washing machine measures the water level to distinguish between functions before looking up values. A click does not verify every threshold on a mechanical device, and it is not a test that applies to an electronic one.

What to investigate in each part

Circuit componentDiagnostic question
Pressure chamber and pathIs the level information getting through without obstruction?
Tube and connectionsAre they connected, intact and airtight?
Sensor and wiringDoes the signal match the conditions of the documented test?
ControlDoes it correctly interpret the signal received?

Overfilling, continuous pumping or a cycle that does not finish are reasons to investigate, not confirmation that the same component is at fault.

Servicing and calibration

Access and measurements should be handled by a competent person. Do not blow into the sensor or adjust screws: improvised pressure or adjustments can cause damage or alter the reference point. Only clean or calibrate it when the manufacturer specifies how to do so.

After a compatible replacement, check the level behaviour during the cycle, not just an isolated signal on the workbench.

View all articles in Washing machine component diagnosis and repair