In designs that use pressure, water changes the pressure of the air trapped in a chamber and tube. The sensor converts that change into a signal that the control interprets as the water level.
From water to signal
As the water rises in the area connected to the chamber, the pressure of the air communicating with the sensor changes. A mechanical pressure switch can change contacts under specified conditions; an electronic sensor provides a signal that is interpreted using its calibration. These devices are not interchangeable.
The control uses this information to limit filling and coordinate operations that depend on the wash water. In a design with a heater, the signal may form part of the conditions that allow heating. The release of phases and protections depends on the specific control logic.
Level, load and flow rate are not the same
- Level: the state of the wash water in the measurement system.
- Flow rate: the amount of water passing through per unit of time when measured.
- Load: an estimate of the laundry, or the mechanical and hydraulic response of the assembly.
An absorbent load may require additional water even if the target level does not change. Cycle adaptation combines information only when the appliance has these functions.
What you cannot tell by looking at the drum
Water below the visible perforations or absorbed into the laundry may form part of the wash water. So a window with no visible water does not, by itself, prove that the machine has not filled.
An overflow detector, if fitted, may provide additional independent protection. To investigate inconsistent signals, you need the water-level system diagnostics, rather than blowing into tubes or adjusting sensors as a universal home test.
Interpret the signal within its complete circuit: chamber, tube, sensor and control, not as an isolated reading from the window.
View all articles in How a washing machine works: systems and components
