Pressure switch and level sensor: fault diagnosis

Level diagnosis should include the pressure chamber, tube and sensor. Replacing only the pressure switch may leave a blockage or leak that continues to affect the reading.

Identify the type of detection

A mechanical pressure switch can switch contacts; an electronic sensor provides a signal that needs to be interpreted differently. Some configurations may also not have the same tube and chamber assembly.

Refer to how a washing machine measures the water level to distinguish their functions before looking for values. A click does not validate every threshold of a mechanical device, and it is not a test that applies to an electronic one.

What to investigate in each part

Circuit partDiagnostic question
Pressure chamber and pathDoes the level information pass through without obstruction?
Tube and jointsAre they connected, intact and airtight?
Sensor and wiringDoes the signal match the conditions of the documented test?
Control unitDoes it interpret the received signal correctly?

Overfilling, continuous pumping or a cycle that does not end are reasons to investigate, not confirmation that the same part is at fault.

Repair and calibration

Access and measurements should be handled by competent personnel. Do not blow into the sensor or adjust screws: improvised pressure or adjustments can damage it or alter its reference point. Clean or calibrate it only when the manufacturer specifies how to do so.

After a compatible replacement, check the level behaviour during the cycle, not just an isolated signal on the workbench.

View all articles in Diagnosing and repairing washing machine components