Siemens E17, F17 or E29 errors: water inlet

On Siemens appliances, E17/F17 indicates that the water supply time has been exceeded, while E29 indicates a water inlet problem. They share some checks, but refer to different alerts.

Compare the message with the E-Nr

The manufacturer's documentation distinguishes the two entries in its table. Copy the code exactly as displayed and use the appliance manual to check the water supply requirements; a pressure or flow figure from another platform is not sufficient.

  1. Check that water is available and the tap is open. Note whether the problem occurred after a water outage or work on the water connection.
  2. Check whether the inlet hose is bent or trapped.
  3. Check the door is closed if this is part of the model's procedure.
  4. If the manual permits you to clean the connection filters, turn off the tap and prepare to disconnect the hose before accessing them.

Do not dismantle or disable a hose safety system. The guide to cleaning inlet mesh filters distinguishes accessible maintenance from an internal repair.

If water is available but the problem continues

Note whether the appliance fills slowly or does not start filling at all. Request an inspection and provide the E-Nr and the complete code, without attributing the result to a specific solenoid valve or sensor.

Correcting the water supply and clearing the message are separate steps; the alert disappearing does not measure the actual flow rate.

View all articles in Siemens washing machine error codes and warnings