E23 on the Siemens models covered in the documentation indicates a leak or water in the base. Turn off the water supply and avoid starting another cycle while the source is being checked.
Record the leak from the outside
The manufacturer's documentation advises turning off the tap if a leak is suspected. Approach from a dry area; if water is near sockets or electrical connections, get help to isolate the appliance without coming into contact with the water.
Check whether the moisture starts at a hose, the detergent drawer, the door seal or underneath the casing. The stage of the cycle also matters: note whether it appears while filling, during washing or while draining. Do not remove panels to locate water in the base tray.
Why drying it is not enough
The floor may be dry while the source of the leak is still active or water remains inside the base. Do not tilt the washing machine to reset the protection. The guide to checking for leaks from the outside helps you record the visible path of the water; it does not confirm that an internal repair is needed.
If the source is not accessible or the warning persists, request service and provide the E-Nr and photographs. Do not treat E23 as a universal instruction to replace a hose or sensor.
Containing the water protects the surrounding area; whether you can wash again depends on resolving the cause.
View all articles in Siemens washing machine error codes and warnings
