F8 E1, LF or Lo FL error on Maytag washing machines: water inlet

F8 E1, LF and Lo FL indicate filling problems on compatible Maytag models. Check the water supply and installation before trying to reset the machine.

Start with the taps, not the control panel

The manufacturer's documentation for Maytag groups alerts for low flow or slow filling. First, check whether the water supply has been interrupted and whether the taps were turned off after installing or moving the machine. On machines with two inlets, open both taps when the manual requires it, even if you have selected a cold wash.

Check the visible length of each hose. If one is crushed, adjust its route without stretching the connections. Inlet screens should only be cleaned using the authorised access point, with the water turned off and the appliance prepared for the task; see how to check these screens.

Water enters but does not stay in the machine

If you hear the machine filling but it keeps waiting, note whether water is draining out at the same time. Compare the installation with the diagram for your model: an incorrectly positioned drain hose may prevent the machine from retaining the required water level.

During a fill-protection cycle, the control may drain the water and temporarily stop responding. Allow it to complete this waiting period and follow the cancellation procedure on the control panel. If the problem returns despite a correct water supply and installation, request a service visit; repeatedly resetting the machine will not help distinguish a blockage from an internal fault.

Note whether both water inlets fail or whether the problem depends on the selected temperature.

View all articles in Maytag washing machine error codes and alerts