F8 E1, LF or Lo FL error on Maytag washing machines: water inlet

F8 E1, LF and Lo FL indicate filling problems on compatible Maytag models. Check the water supply and installation before trying to reset the machine.

Start with the water supply, not the control panel

The manufacturer’s documentation for Maytag groups together alerts for low flow or slow filling. First check whether the water has been turned off and whether the taps were shut after the machine was installed or moved. On models with two water inlets, open both taps if the manual requires it, even if you have selected a cold wash.

Check the visible section of each hose. If one is crushed, adjust its route without straining the connections. Inlet screens should only be cleaned using the authorised access method, with the water turned off and the appliance prepared for the task; see how to check the screens.

Water enters but does not stay in the machine

If you can hear the machine filling but it keeps waiting, note whether water is also draining away at the same time. Compare the installation with the model’s diagram: an incorrectly positioned drain hose can prevent the machine from retaining the required water level.

During a fill protection cycle, the control may drain the machine and temporarily stop responding. Allow it to complete the wait and follow the cancellation procedure on the control panel. If the fault returns despite a correct water supply and installation, arrange a service visit; repeatedly resetting the machine will not distinguish a restriction from an internal fault.

Note whether both water inlets fail or whether the problem depends on the selected temperature.

View all articles in Maytag washing machine error codes and alerts