How to check and replace the drain pump

To confirm a pump fault, first rule out a blocked outlet and a fault with the pump assembly itself or its control. Hearing it run does not prove that it is pumping out the required flow.

What to check before replacement

This is part of diagnosing water not draining. A blocked filter, a kinked hose or an external problem can prevent draining even when the pump is intact.

The technical inspection should distinguish between a damaged impeller, a leak from the housing or seal, an electrical fault and a lack of control signal. The resistance felt when moving an impeller can depend on its design; slight notches do not prove that it is faulty.

Preparation and scope of replacement

  1. Use the exploded diagram to identify whether to replace the motor or the complete assembly, and check its compatible part number.
  2. Isolate the power and water supplies, carry out safe draining and prepare to catch residual water.
  3. Gain access using the procedure for that platform, keeping track of the position of pipes, fixings and connections.
  4. Replace the specified seals and components, refit all guards and carry out the prescribed checks.

Electrical measurements require the correct specifications and suitable instruments. Do not connect a loose pump directly to the mains or use a resistance value taken from another model.

What to check afterwards

It should drain properly and be watertight at the joints you have worked on. If water is dripping from the filter cap, check that seal rather than assuming a new motor will fix it.

Replacing the pump without checking the drainage path may leave the same blockage and the same inadequate drainage.

View all articles in Washing machine component diagnosis and repair