
To locate a leak, note where the water first appears and which cycle phase it occurs in. The final puddle may be far from the source because water can travel along the cabinet or floor.
Stop the leak before investigating
Stop using the washer and shut off the water supply if you can do so safely. If water has reached electrical connections, don’t touch plugs or the cabinet to check; isolate the power from a dry, safe location. Don’t run the washer with its panels open to inspect the inside.
Where the water first appears guides your inspection
- Water under the appliance: note whether it appears while filling, washing or draining, and whether there has been any recent maintenance.
- Leak around the door: check the contact surface, gasket and alignment.
- Overflow from the detergent drawer: distinguish water from suds, and note when the detergent is dispensed.
- Dripping from the filter or cap: check whether it started after opening the drain access.
An external inlet connection can leak even when the washer is idle if it remains under pressure. A household drain that overflows during pumping points to a plumbing issue, even if the puddle surrounds the washer.
Details worth keeping
Note the cycle, load and whether you had just cleaned a filter, repositioned the detergent drawer or moved the appliance. These changes can help you decide what to check first. Don’t apply glue or sealant to a connection until you’ve identified its sealing method.
Frequently Asked Questions
Does the location of the puddle always identify the leaking part?
No. Water can run down the front or travel along a hose before dripping. Where it first gets wet tells you more than the centre of the puddle.
Can a leak occur only during certain cycles?
Yes. The water level, dispensing phases, movement and draining operations vary. That connection can help you locate the leak without confirming a specific part.
Can I keep using the washer if the leak is small?
Don’t assume it’s safe because the leak is small. Water could reach electrical connections or the leak could get worse. Stop using the washer until you identify and fix the source.
A follow-up test only makes sense once the cause has been fixed and all connections and protective covers have been restored.




