The washer-dryer finishes drying too early

If drying ends early and the clothes are still damp, check whether the controls indicated that the cycle had finished or whether it was interrupted. The size and mix of the load, and the selected dryness level, can affect when the automatic programme ends.

Programme finished or unexpected interruption

Keep a note of the message and check whether the control panel is still on. Returning to the home screen may indicate switching off or restarting; a thermal error needs a different assessment from a normal cycle end.

Check the load and setting

Check whether you selected a dryness level that leaves clothes damp for ironing. See whether you mixed fine garments with thicker items, or whether the load is too small for the model’s automatic programme. The detection system may respond differently depending on contact and how the load is distributed.

Not all appliances use accessible moisture sensors or the same calculation method. Clean only the surfaces identified in the manual, and do not sand any presumed sensor strips.

A permitted comparison, with no signs of risk

If the manufacturer recommends a test load and settings, follow them after checking the filters and settings. Do not add time or increase the temperature based on guesswork if there is excessive heat, an odour or interruptions: see drying overheating.

If it finishes again without the expected result under approved conditions, the circuit diagnosis should distinguish between detection, airflow and heat generation. An incorrectly assessed small load does not confirm a faulty sensor.

Tell the service team which indicator appears when the cycle ends and which items are still damp; this helps distinguish a control decision from a loss of function.

View all articles in Washer-dryer not drying properly: system-based diagnosis