The washer-dryer finishes drying early

If drying finishes early while clothes are still damp, check whether the control indicated that the cycle had finished or whether it was interrupted. The load size and mix of items, and the selected dryness level, can affect automatic cycle completion.

Cycle finished or unexpected shutdown

Note the message and check whether the panel is still on. Returning to the home screen may indicate a shutdown or restart; a thermal error needs a different assessment from a normal cycle finish.

Check the load and setting

Check whether you selected a dryness level that leaves clothes damp for ironing. See whether you mixed fine fabrics with thicker items, or whether the load is too small for the model’s automatic programme. The detection system may respond differently depending on contact and how the load is distributed.

Not all appliances use accessible moisture sensors or the same calculation method. Clean only the surfaces identified in the manual and do not sand any suspected sensor strips.

A permitted comparison, with no signs of risk

If the manufacturer recommends a test load and settings, follow them after checking the filters and settings. Do not add time or increase the temperature based on guesswork if there is excessive heat, an odour or shutdowns: see drying overheating.

If it finishes again without the expected result under approved conditions, the circuit diagnosis should distinguish between detection, airflow and heat generation. A small load being assessed incorrectly does not confirm that a sensor is faulty.

Tell the service technician which indicator appears when the cycle finishes and which clothes are still damp; this helps distinguish a control decision from a loss of function.

View all articles in Washer-dryer not drying properly: system-based diagnosis