If drying ends early with clothes still damp, check whether the control indicated the cycle was finished or whether there was an interruption. Load size and mix, along with the selected dryness level, can affect automatic cycle completion.
Cycle completion or unexpected interruption
Keep the message and check whether the panel is still on. A return to the home screen may indicate power off or restart; a thermal error requires a different assessment than normal cycle completion.
Check the load and setting
Check whether you selected a dryness level that leaves clothes damp for ironing. Check whether you mixed lightweight garments with thick items or the load is too small for the model’s automatic cycle. The detection system may respond differently depending on contact and distribution.
Not all appliances use accessible moisture sensors or the same calculation method. Clean only the surfaces identified in the manual, and don’t sand supposed sensor strips.
A permitted comparison test, with no signs of risk
If the manufacturer recommends a test load and setting, follow them after checking the filters and setting. Don’t add time or temperature based on guesswork if there is excessive heat, an odour or shutdowns: see dryer overheating.
If it finishes again without the expected result under permitted conditions, the circuit diagnosis should distinguish between sensing, circulation and heat generation. A small load that was assessed incorrectly does not confirm a faulty sensor.
Tell the service technician which indicator appears when the cycle ends and which items remain damp; this helps distinguish a control decision from a loss of function.
View all articles in Washer-dryer not drying properly: system-based diagnosis
