The washer-dryer finishes drying early

If the drying cycle ends early and the clothes are still damp, check whether the control indicated that the cycle had finished or whether it was interrupted. The load size and mix, and the selected dryness level, can affect automatic cycle completion.

Programme end or unexpected interruption

Note the message and check whether the panel is still on. A return to the home screen may indicate power-off or restart; a thermal error needs a different assessment from a normal cycle end.

Check the load and setting

Check whether you selected a dryness level that leaves clothes damp for ironing. See whether you mixed thin garments with thick items, or whether the load is too small for the model’s automatic programme. The detection system may respond differently depending on contact and distribution.

Not all appliances use accessible moisture sensors or the same calculation method. Clean only the surfaces identified in the manual, and do not sand any supposed sensor strips.

A permitted comparison, with no signs of risk

If the manufacturer recommends a test load and setting, follow them after checking the filters and setting. Do not add time or increase the temperature based on guesswork if there is excessive heat, an odour or interruptions: see drying overheating.

If it again finishes without the expected result under approved conditions, the circuit diagnosis should distinguish between detection, circulation and heat generation. A small load that is assessed incorrectly does not confirm a faulty sensor.

Tell the service technician which indicator appears when the cycle ends and which clothes are still damp; this helps distinguish a control decision from a loss of function.

View all articles in Washer-dryer not drying properly: diagnosis by system