When a washer-dryer does not dry properly, internal diagnosis should check how air circulates, how heat is generated and how moisture is removed. The order depends on the system fitted and the confirmed symptom.
Identify the system in the same drum
A machine with a heating element, one that vents air and one with a heat pump cannot be inspected as if they were identical. The manual and parts diagram identify the relevant fan, ducts, sensors and condensate management system.
Before dismantling, rule out insufficient drying and a prolonged or interrupted programme. Damp laundry due to the load or programme selection does not prove that the heater is faulty.
What the inspection should distinguish
- Air circulation: the route, obstructions and fan operation.
- Heat supply: components and controls specific to the system design.
- Temperature sensing and protection: sensors, connections and conditions that trigger a cut-out.
- Moisture outlet: condensate, drainage or venting, depending on the machine.
An accessible obstruction may be suitable for maintenance by an authorised person; internal ducts require the correct servicing procedure. Filters and access points vary between models.
Repair and final checks
Tests should relate each component to the condition observed. If there is excessive heat or an unusual smell, stop using the machine and investigate the cause. Resetting a thermal cut-out without correcting the underlying fault is not a repair.
Dismantling and live electrical measurements must be carried out by a competent person. The refrigerant circuit in a heat-pump machine requires specialist servicing. After repair, check the integrated function and restore the ducts, seals and protective devices; do not adapt a procedure intended for a standalone tumble dryer.
The quote should state which part of the air, heat or moisture route has failed and how it will be checked afterwards, rather than grouping everything together as a drying problem.
View all articles in Washing machine component diagnosis and repair
