Top-loading washing machine fills but does not agitate

If a top-loading automatic washing machine fills but does not wash by moving the clothes, check that it has finished sensing or soaking and that it recognises the lid. Then check whether it still spins.

Check the programme’s actual stage

Low noise and water can conceal brief movements. From the outside, check the status shown on the control panel and use only the pause and lid-opening procedures allowed by the manual. Do not hold the lid open or bypass its sensor.

GE provides its own diagnostic guidance for top-loading washing machines that fill but do not agitate; a reset sequence for one particular range should not be applied to every machine.

What information helps distinguish the causes

  • If the cycle is waiting for the lid to close, check whether the lid is being recognised before suspecting the motor.
  • If you hear the drive operating but the washplate or clothes do not move as they did before, the fixing, splines or transmission may be involved.
  • If it also fails to spin, the fault may affect components shared by both operations, or a condition that prevents either operation.
  • If this started after a load containing hard objects, stop using the machine if you hear rubbing or it becomes jammed.

Inspecting the agitator or impeller and the transmission requires identifying the exact construction. Do not use levers to lift the washplate, or infer the condition of the shaft from a single feeling of looseness.

A semi-automatic machine with independent controls follows a different troubleshooting process: see twin-tub washer pulsator not spinning.

Report whether the clothes change position during pauses permitted by the manual and which operations the machine does complete; there is no need to observe the mechanism with the machine opened up.

View all articles in Turning, agitation and spinning faults