The washing machine trips the RCD, circuit breaker or fuse

If an electrical safety device trips while you are using the washing machine, stop testing and isolate the appliance from a safe place. The trip may be related to the appliance, the electrical installation or a combination of loads.

Identify the safety device without opening the consumer unit

The terms RCD, circuit breaker and fuse are used differently from one country to another. An RCD detects an imbalance in current; other devices protect against overcurrent, and some devices combine both functions. Note down the identification shown on the device and pass this information on to a qualified professional.

The timing can help, but does not confirm which part is faulty

  • When connecting: check the power supply, connections and circuits that are energised from the start.
  • During heating: the heating circuit and its insulation need to be checked.
  • When spinning or draining: note which loads were operating.
  • If there is a leak: the presence of moisture changes the safety priorities.

Bosch lists the motor, heater, wiring and water on components among the possible causes in its guidance on electrical trips. It does not attribute every incident to the same part.

What needs checking

An electrician should assess the supply and protective devices when the problem appears to involve the circuit. An appliance repair service should check the heater, drive system and other components as indicated by the symptoms. If there are water leaks, these should be fixed too.

Do not increase the fuse or circuit-breaker rating, replace a fuse with an improvised substitute, disconnect the earth or keep resetting the device. Changing the protective device so that it does not trip hides the warning that needs investigating.

Note when it happened and which other appliances were operating; do not cause another trip just to complete the record.

View all articles in Electrical and heating faults in washing machines