The washing machine trips the RCD, circuit breaker or fuse

If an electrical safety device trips while you’re using the washing machine, stop testing and isolate the appliance from a safe location. The trip may be related to the appliance, the electrical installation or a combination of loads.

Identify the safety device without opening the switchboard

Terms such as RCD, circuit breaker and breaker vary between countries. An RCD detects an imbalance in current; other devices protect against overcurrent, and some devices combine both functions. Note the visible identification and pass this information on to a professional.

The timing can help, but it doesn’t confirm a faulty part

  • When connecting: check the power supply, connections and circuits that are energised from the outset.
  • During heating: the heating circuit and its insulation should be assessed.
  • During spinning or draining: note which loads were operating.
  • If there’s a leak: the presence of moisture changes the safety priority.

Bosch lists the motor, heater, wiring and water on components among the possible causes in its guidance on electrical trips. It doesn’t attribute every incident to the same part.

What needs to be checked

An electrician should assess the power supply and safety devices when the problem points to the circuit. An appliance service technician should check the heater, drive and other components based on the signs. Any water leaks should also be fixed.

Don’t increase the fuse or circuit breaker rating, substitute a makeshift fuse, disconnect the earth or keep resetting the device. Changing the protection so it doesn’t trip hides the warning that needs investigating.

Note when it happened and which other appliances were operating; don’t cause another trip just to complete the record.

View all articles in Electrical and heating faults in washing machines