If an electrical protective device trips while you’re using the washing machine, stop testing and isolate the appliance from a safe location. The trip may be related to the appliance, the electrical installation or a combination of loads.
Identify the protective device without opening the electrical panel
The terms GFCI, breaker and circuit breaker are used differently from country to country. A residual-current device detects an imbalance in current; other devices protect against overcurrent, and some combine both functions. Note the visible identification and give the information to a qualified professional.
The timing can help, but it doesn’t confirm a specific part
- When you plug it in: check the power supply, connections and circuits that receive power right away.
- During heating: the heating circuit and its insulation should be assessed.
- During spinning or draining: note which loads were operating.
- If there’s a leak: the presence of moisture changes the safety priority.
Bosch lists the motor, heater, wiring and water on components among the possible causes in its guidance on electrical trips. It doesn’t attribute every incident to the same part.
What inspection you need
An electrician should assess the power supply and protective devices when the problem appears to be in the circuit. An appliance service technician should check the heater, drive system and other components based on the evidence. If there are water leaks, those should be fixed too.
Don’t increase the breaker rating, replace a fuse with an improvised substitute, disconnect the ground or keep resetting the device. Changing the protective device so it won’t trip hides the warning that needs to be investigated.
Note when it happened and which other appliances were running; don’t cause another trip just to complete the record.
View all articles in Electrical and heating faults in washing machines
