The washing machine trips the RCD, circuit breaker or fuse

If an electrical protective device trips while you are using the washing machine, stop testing and isolate the appliance from a safe location. The trip may be related to the appliance, the electrical installation or a combination of loads.

Identify the protective device without opening the distribution board

Terms such as RCD, automatic circuit breaker and circuit breaker are used differently across countries. An RCD detects an imbalance in current; other devices protect against overcurrent, and some devices combine both functions. Note down the visible identification and share it with the professional.

The timing can help, but it does not confirm which part is faulty

  • When switching on: the power supply, connections and circuits energised from the start are relevant.
  • During heating: the heating circuit and its insulation should be assessed.
  • During spinning or draining: note which loads were operating.
  • If there is a leak: the presence of moisture changes the safety priority.

Bosch lists the motor, heater, wiring and water on components among the possible causes in its guidance on electrical tripping. It does not attribute every incident to the same part.

What needs to be checked

An electrician should assess the supply and protective devices when the problem appears to be with the circuit. The appliance service technician should check the heater, drive system and other components based on the evidence. Any water leaks should also be fixed.

Do not increase the rating, replace a fuse with an improvised alternative, disconnect the earth, or keep resetting the device. Changing the protective device so that it does not trip hides the warning sign that needs to be investigated.

Note when it happened and which other appliances were operating; do not cause another trip just to complete the record.

View all articles in Electrical and heating faults in washing machines