Before assuming the automatic dosing system is faulty, check that it is enabled for the cycle, that the product is compatible and that the reservoir is correctly positioned. The smell of the laundry does not indicate how much detergent has been dispensed.
Rule out settings and product supply
- Check the manual to confirm that the programme supports the feature and that it is selected.
- Check the concentration and dose settings for the product being used.
- Check that the reservoir is filled, is the correct one and is properly seated, without exceeding the indicated marks.
- Only carry out the automatic dosing system cleaning authorised for that model.
A conventional detergent drawer that leaves product behind requires troubleshooting of detergent dispensing and flushing; this does not mean there is an automatic pump.
How to interpret the refill warning
A full reservoir with a warning does not confirm that a sensor is faulty. In the machines described in this Samsung support guide, the warning may remain until the next dose is dispensed. Check what is expected for your model.
If the problem persists, with no product dispensed or too much dispensed despite the correct settings, a technician should check the suction, air in the circuit, blockages, pump and level detection in accordance with the design.
When it needs repairing
The repair may involve the pipes, dosing unit or electronic control. The diagnosis and replacement part identification should specify which component is being supplied and how the dispensed amount is verified.
Do not use a universal priming procedure, insert tools into the inlets or open sealed cartridges. If the manual allows an alternative manual dosing method, follow its instructions to avoid a double dose.
Record the product, selected concentration, cycle and exact message: this information helps distinguish a pending warning from a persistent failure to dispense.
View all articles in Washing machine component diagnosis and repair
