Auto-dosing doesn’t dispense or dispenses the wrong amount

Before assuming the auto-dosing system is faulty, confirm that it’s enabled for the cycle, that the product is compatible and that the reservoir is properly seated. The smell of the laundry doesn’t tell you how much detergent was dispensed.

Rule out settings and product supply issues

  1. Check the manual to confirm that the program supports the function and that it’s selected.
  2. Check the concentration and dosage settings for the product being used.
  3. Check that the reservoir is filled, is the correct one and is properly seated, without exceeding the indicated marks.
  4. Only perform the auto-dosing system cleaning approved for that model.

A conventional detergent drawer that leaves product behind requires diagnosis of detergent dispensing and flushing; it doesn’t mean there’s an automatic pump.

How to interpret the refill alert

A full reservoir with an alert doesn’t confirm that a sensor is faulty. On the appliances described in this Samsung support article, the alert may remain until the next dose is dispensed. Check the expected behaviour for your model.

If too little or too much product continues to be dispensed despite correct settings, a technician should distinguish between suction, air in the line, blockages, the pump and level detection, based on the design.

When it needs repair

The repair may involve the tubing, dispenser assembly or electronic control. The diagnosis and replacement part identification should specify which component is being supplied and how the dispensed amount will be verified.

Don’t perform a universal purge, insert tools into the inlets or open sealed cartridges. If the manual allows manual dosing as an alternative, follow its instructions to avoid dispensing a double dose.

Record the product, selected concentration, cycle and exact message. This information helps distinguish a pending alert from a persistent failure to dispense.

View all articles in Washer Component Diagnosis and Repair