HC indicates that the hot and cold water connections are reversed on the documented Whirlpool HE top-loaders. It applies only to machines that use both inlets.
Check the route of each hose
The manufacturer’s documentation identifies HC at the end of the cycle. Before changing anything, identify the household hot and cold outlets and the markings on the washing machine inlets. Trace each hose from end to end; its colour alone does not confirm the connection.
- Stop the machine and turn off both taps.
- If the manual allows you to correct these connections and you can access them without pulling the machine out, have a container ready for residual water.
- Connect each water supply to its inlet according to the model diagram, keeping the approved washers and hoses in place.
- Turn the water supply back on and check the connections for drips before running the permitted test cycle.
If you can’t identify an outlet or access requires moving a heavy or stacked appliance, ask the installer for help. The guide to a hot or cold tap that isn’t working distinguishes a reversed connection from a lack of water supply.
HC after correcting the installation
Note when it reappears and which connections were checked. A persistent message requires diagnosis; don’t keep swapping the hoses or apply this meaning to a single-inlet Whirlpool machine.
The check is complete when the connections are correct and leak-free, not merely when HC disappears.
View all articles in Whirlpool washing machine error codes and alerts
