HC warning on a Whirlpool washing machine: water connections reversed

HC indicates that the hot and cold water connections are reversed on the documented Whirlpool HE top-load washers. This applies only to machines that use both inlets.

Check the route of each hose

The manufacturer documentation places HC at the end of the cycle. Before changing anything, identify the household hot-water outlet, the cold-water outlet and the markings on the washing machine inlets. Trace each hose from one end to the other; its colour alone does not confirm the connection.

  1. Stop the machine and turn off both taps.
  2. If the manual permits you to correct these connections and you can access them without pulling the machine out, keep a container ready for any residual water.
  3. Connect each water supply to its inlet according to the model diagram, keeping the approved washers and hoses in place.
  4. Turn the water supply back on and check that the joints are not leaking before running the permitted test cycle.

If you cannot identify an outlet or access requires moving a heavy or stacked appliance, ask the installer for help. The guide to a hot or cold water supply that is not working distinguishes a reversed connection from a lack of water supply.

HC after correcting the installation

Note when it reappears and which connections were checked. A persistent message requires diagnosis; do not repeatedly swap the hoses or apply this meaning to a single-inlet Whirlpool washing machine.

The check is complete when the connections are correct and leak-free, not merely when HC disappears.

View all articles in Whirlpool washing machine error codes and alerts