Error E10, E11 or C1 in Electrolux washing machines: water supply

On compatible Electrolux models, E10, E11 and C1 indicate problems with the water circuit. On some control panels, the same family of codes is signalled by a beep or flashing light.

Describe the filling problem

The manufacturer's documentation covers failure to fill, insufficient filling and related problems with the water flow. Check the household water supply and the washing machine tap before trying to reset the appliance.

If the machine starts taking in water, check whether it continues to enter slowly or drains away at the same time. An incorrectly installed outlet can cause siphoning; check the height and connection against the PNC-specific manual.

Check what you can access

Look for kinks in the hoses. Clean the mesh filters only if the manual authorises access to them: turn off the water, prepare to disconnect the hose, then refit the filter and seal afterwards. Check that the joint does not leak. The guide to inlet mesh filters explains this procedure further.

If there is foam, check the dosage and detergent as an additional factor, not as an automatic explanation for every E10 error. If the external water route is correct and the warning returns, contact a service technician and provide the full code. Do not assume that the valve is faulty just because there is no water in the drum.

Have the PNC to hand when you contact us: the dimensions and controls of another Electrolux model may not be the same.

View all articles in Electrolux washing machine error codes and warnings