First use of a washing machine: installation test and initial cycle

The first use should verify the installation by following the procedure for your model. There is no empty cycle, detergent dose or first-use temperature that applies to every washing machine.

Before powering on

Confirm the model and documentation, packaging has been removed, shipping bolts have been dealt with, and the feet are stable. Check the water inlet, drain and power cord for anything that could trap or pinch them. The connections must be compatible before running a test: completing a cycle does not validate an unknown electrical installation.

Follow the applicable procedure

The manual may call for an empty wash, removal of manufacturing residue or an installation test. Use only the product, programme and preparation specified. If initial calibration is included, check whether it is available and what order to follow; the Samsung sequence applies only to compatible machines.

External checks during the test

  • Water enters without visible leaks at the connections.
  • Water drains without overflowing or backing up, and the hose stays in place.
  • The machine runs steadily, without violent banging or shifting.
  • There is no electrical odour, smoke or unusual heating at the connections.
  • The test finishes, and any messages are consistent with the procedure.

Stay in a safe position and do not remove panels to observe. If a leak or hazardous behaviour occurs, stop using the machine and shut off the supplies from safe locations; do not repeat the test to see if the problem goes away.

If the test does not finish

Keep a record of the message, stage and observations, and check with support or the installer about the outstanding issue. The installation must be resolved before you put in the first load of laundry.

Record the test result and any adjustments made; this baseline makes it easier to interpret changes later.

View all articles in Starting up and setting up a washing machine