The floor must support the appliance and limit flexing during operation. Adjusting the feet corrects how it sits; it does not prove that a platform or floor structure is sufficiently rigid.
Level and stiffness answer different questions
A level can check the orientation of a surface or appliance. Stiffness describes how much the support deforms under load. A floor can be level yet flex during the spin cycle; it can also be rigid but need the feet adjusted so they all make contact.
The suspension reduces some of the movement, but still transmits forces to the installation site. Noise heard in another room may depend on this structural transmission as well as the sound emitted through the air.
Material and actual structure
Concrete, a wood floor or an upper storey are not enough on their own to establish suitability. The actual thickness and construction, condition, supports and location all matter. If the manual specifies characteristics you cannot confirm, the installation needs to be assessed by the installer or a structural professional—not tested with violent spin cycles.
Bases, pads and wheels
A soft mat can affect stability and make it difficult for all the feet to sit evenly. A base with wheels must be approved and locked as intended. Pads cannot make up for inadequate suspension or flooring.
The pedestal adds height and puts forces on the fasteners. Before installing accessories, check that the setup is compatible and that service access is maintained. Then follow the applicable levelling instructions.
If a machine that was previously stable starts moving, do not assume the floor is to blame: the change may be due to the load, fasteners or components. Reading the stated noise level does not diagnose this behaviour either.
Confirm the support first, then check how the machine sits; adding a layer underneath does not replace either check.
View all articles in Washing machine installation: requirements and checks
