Water builds up during washer-dryer drying

Some systems use water during drying, but any visible build-up should not be assumed to be normal. If the water level rises enough to wet the clothes again, check the water inlet and drainage in line with the appliance design.

A designed water inlet is not the same as a flooded drum

In water-cooled condensation systems, the water supply helps remove moisture from the air, and the circuit drains away the resulting water. Not all appliances work this way; a heat pump may include other functions that also use water.

For example, the LG F4X7*FPY* manual requires the cold-water tap to remain open during its drying cycles. This instruction applies to the documented product range and does not define how all washer-dryers work.

What to record if water builds up

  • Whether the water appears before drying or increases after the cycle has started.
  • Whether you can hear the pump, and whether drainage worked at the end of the wash.
  • Whether water continues to enter after the cycle has stopped.
  • Whether there is an error message, water returning from a pipe, or a visible leak.

A drainage failure can leave water in the circuit. An inlet that does not close requires the valve to be assessed; the drying circuit should be checked if the problem depends on how it manages condensate.

Do not turn off the tap as a routine solution without checking the manual. If the water level rises uncontrollably, stop using the appliance and safely turn off the water supply to contain the leak.

Do not assume it is normal for clothes to get soaked again just because the appliance uses water during drying: an abnormal water level needs to be diagnosed.

View all articles in Washer-dryer not drying properly: system-based diagnosis