Tachogenerator and Hall sensor: diagnosing motor speed

Irregular acceleration may make it necessary to check rotation information, but it does not by itself identify a faulty sensor. First, you need to know how the drive system in that model obtains this information.

Three architectures that are not equivalent

Some motors use a tachogenerator; others have Hall sensors, while some controls estimate rotation without a separate sensor that can be replaced as a component. The parts diagram and wiring diagram determine which type is present and whether it is supplied separately from the motor.

This component reports motor movement. It should not be confused with a vibration sensor or a decision by the appliance to limit the spin cycle due to other conditions.

Trace the signal to the control

  1. Identify the specified sensor, mounting and connections.
  2. Check the wiring and connectors using the procedure for working with the power off.
  3. Check the signal and its operating conditions against the technical documentation.
  4. Assess how it is received by the electronic module and whether the drive system produces the requested movement.

Jerking, loss of acceleration or a related error code can point to this area, but may also occur with faults in the motor and its control. The meaning of the code depends on the manufacturer and model.

Limitations of testing

A measurement requires conditions, terminals and values specific to that circuit. Active signals and any tests involving live power should be handled by competent personnel with the appropriate equipment. Do not interchange terminals or test resistance values published for another product family.

Before replacing the sensor, the diagnosis should distinguish between a genuine absence of signal, a break in the wiring and a reading fault in the control.

View all articles in Washing machine component diagnosis and repair