Irregular acceleration may make it necessary to check the rotation feedback, but it does not by itself identify a faulty sensor. First, you need to find out how the drive system in that model obtains this information.
Three architectures that are not interchangeable
Some motors use a tachogenerator; others have Hall sensors, while certain controls estimate rotation without a separate sensor that can be replaced as a part. The parts diagram and wiring diagram will show which type is fitted and whether it is supplied separately from the motor.
This component provides information about motor movement. It should not be confused with a vibration sensor or with the appliance deciding to limit the spin cycle for other reasons.
Trace the signal to the control
- Identify the specified sensor, mounting and connections.
- Check the wiring and connectors using the procedure for working with the power off.
- Check the signal and its operating conditions against the technical documentation.
- Assess how it is received by the electronic module and whether the drive system produces the requested movement.
Jerking, loss of acceleration or a related error code can point to this issue, but may also occur with faults in the motor and its control. The meaning of the code depends on the manufacturer and model.
Limitations of testing
A measurement requires conditions, terminals and values specific to that circuit. Active signals and any testing with the power on should be handled by a competent person with the appropriate equipment. Do not swap terminals or test resistance using values published for a different product range.
Before replacing the sensor, the diagnosis should distinguish a genuine loss of signal from a break in the wiring or a reading fault in the control.
View all articles in Washing machine component diagnosis and repair
